To Next PageTo Next Page
Need help?Do you have a question about the AMI Marine X300 and is the answer not in the manual?
General| Brand | AMI Marine |
|---|---|
| Model | X300 |
| Category | Test Equipment |
| Language | English |
Compact and ultra-light NMEA 0183 testing tool with oscilloscope function.
2.8" TFT LCD screen, power switch, NMEA input, USB data transfer, and wave output.
Navigate menus, confirm selections, change values, run/stop, and save files.
Contact technical support via email or visit the website for assistance and products.
Take care not to connect probes to the wave out port to avoid damage.
Details analogue bandwidth, input voltage, sensitivity, trigger modes, measurements, and signal generator.
Illustrates oscilloscope screen with settings like mode, division, trigger, and measurements.
Select NMEA Monitor mode to view raw data or summarized NMEA sentences.
Configure baud rate, stop bits, and parity for NMEA communication.
Device automatically detects incoming data baud rate by holding the 'A' button.
Identifies errors like no data, checksum, or length issues via color codes.
Choose NMEA sentence type and specific fields for data generation.
Modify selected NMEA data fields using left/right buttons.
