Amica SHC User Manual

*optional
11
ELECTRONIC PROGRAMMER (optio-
ELECTRONIC PROGRAMMER*
A - display field
B - work function symbols
- work time
- turn-off time
- timer
- current time
- signal lamp
1 - programmer work function selection
button
2 - button „-”
3 - button „+”
CURRENT TIME SET-UP
After plugging in or reconnecting to a power
source after current decay, the display shows
12.00, and the lamp at flashes,
• set up the current time using buttons
2 and 3.
About 5 sec. after the time set-up has been
finished, new data will be memorized and the
lamp at will go out.
The time correction can be done later, press
-
ing button
1 until the lamp at starts to flash.
Then you can correct the current time.
Notice!
If the current time is not set up, it is impossible
for the oven to work.
A
2
B
3
B
1
TIMER
You can activate the timer at any time, regard
-
less the activity state of other programmer
functions. The measured time ranges from 1
minute to 23 hours 59 minutes. With the aim
of setting up the timer:
• press button 1 until the lamp at
starts to flash, and the display
shows “0.00”,
• set up the timer using buttons 3 and
2,
The set-up time is presented on
the display, and the lamp at
is
turned on.
After the set-up time has elapsed, a sound
signal turns on and the lamp at
starts to
flash again,
• press buttons 1, 2 or 3 to turn the
signal off; the lamp will go out, and
the display will indicate the current
time.
Notice!
If the sound signal is not turned off manu-
ally, it will turn off automatically after about
2 minutes.
OPERATION

Amica SHC Specifications

General

Number of burners	4
Oven type	Electric
Energy efficiency class	A
Height	85 cm
Depth	60 cm
Number of cooking zones	4
Residual heat indicator	Yes
Timer	Yes