AMP Command Pro iii 9500 - Page 28

24
9 Common fault and processing methods
fault
phenomenon
fault cause
failure process
Could not
start
1. battery low voltage
2. fuel cock not open
3. Chock valve not open
4. Low oil level
5. Oil warning system problem
6.Bad fuel oil quality
7.0il circuit block
8.1gnition system problem
9.Carburetor problem
1 ,
2.
3.
4.
5.
6. 7.
8.
9.
charge battery( only for electric
start)
Open fuel cock
Refer step 3
Check oil level, add to the level
Pull up warning wire, restart to
confirm (after confirm should
stop machine)
Change fuel oil
Clean oil circuit
Check and clean spark plug,
check ignition coil.
Clean or repair carburetor