Easy Operation Steps
1. Open the terminal covers.
3. Connect the black negative (-) ring
terminal cable to the black negative
(-)terminals of the battery and inverter.
2. Connectthe red positive (+)ring terminal
cable to the red positive (+) terminals of the
battery and inverter.
4. Turn on the inverter power switch and
plug in your appliance.
Make sure the inverter is turned OFF when not in use.
Open the terminal covers method
1. Turn the plastic screw
counter-clockwise with
your finger or wrench.
2. Remove the plastic
screws.
3. Remove the plastic cover
and start wiring.
To Next Page
Loading...