Insert the Setup CD
— R E A D F I R S T —
SETUP GUIDE
UA150C
High Power Wireless-150N Compact USB Adapter
C. Continue the Driver Installation
Follow the instructions that appear and click
Install to continue the installation.
D. Restart your Computer
A prompt will appear asking you to restart your
computer. Select Yes and click Finish to restart.
E. Insert the High Power USB Adapter
After the computer has fully rebooted, locate an
available USB port and insert the USB Adapter.
Windows should automatically begin installing the
driver for use with the USB Adapter.
F. Connect to a Wireless Network
Locate the Wireless Icon in the Windows System
tray (bottom right corner) and click it to view
available wireless networks. Highlight your
desired network and click Connect.
G. Connect to a Wireless Network
If the network you are trying to connect to has
security enabled you will need to enter it here.
B. Start the Driver Installation
If prompted, click Yes to begin the installation.
A. From the Menu page, select Install Software
If the Menu page does not appear, browse the
CD drive and double-click the Autoload.exe file
Install Software
Windows 7 and Vista
2
Follow the Instructions for your Operating System:
C. Restart your Computer
A prompt will appear asking you to restart your
computer. Select Yes and click Finish to restart.
D. Insert the High Power USB Adapter
After the computer has fully rebooted, locate an
available USB port and insert the USB Adapter.
The Found New Hardware Wizard should appear.
E. New Hardware Wizard
When the New Hardware Wizard appears and asks
to search for software, select No, not this time.
Click Next to continue.
F. New Hardware Wizard
When prompted by the New Hardware Wizard to
install the software, select Install the Software
Automatically (Recommended) and click Next.
B. Start the Driver Installation
Click Next to begin the installation. Follow the
instructions that appear and click Install to
continue.
A. From the Menu page, select Install Software
If the Menu page does not appear, browse the
CD drive and double-click the Autoload.exe file
G. Connect to a Wireless Network
Once Windows has completed the software installation
locate the Amped Wireless Utility icon and open the
software by double-clicking the icon. Select the
Available Network tab to view nearby networks.
H. Connect to a Wireless Network
Highlight the network that you wish to connect to
and double-click it to connect. If your network
has security enabled, you can enter it in the
Network Key field and click OK.
Windows XP and 2000
Amped Wireless
USB Wireless-N Driver
and Utility
1
The menu page should appear.
Select the instructions for your operating system
below and install the driver for the USB adapter.
Windows Instructions: This Side
Mac Instructions: Back Side
Do not insert the USB Adapter until after the
software/driver has been fully installed.
3
IMPORTANT:
DO NOT INSERT THE USB ADAPTER
UNTIL THE DRIVER HAS BEEN INSTALLED
Need Help? Give us a call.
Phone: 888-573-8820
Email: techsupport@ampedwireless.com
Web: www.ampedwireless.com/support
?
To Next Page
Need help?
General
