No networks appear in the scan results.
a. The wireless adapter may be out of range. Double check that the antenna is secured tightly to the
adapter and scan for wireless networks again.
b. Verify that the adapter is firmly inserted into your USB drive and try to scan for networks again.
c. Check to see that the wireless network you are connecting to is functioning correctly. If possible,
locate your wireless router and see that the wireless LED is blinking correctly. If not, check the
connection and configuration of your wireless router.
d. (Mac Solution)You may need to activate your wireless adapter. Click the Apple icon, select System
Preferences, then click on Network. Highlight the adapter titled Ethernet Adaptor (en#) for OS X 10.5
and below and click Advanced, then click Apply. For OS X 10.6, select the adapter titled 11n Adapter
and click Apply. Try to scan for networks again.
e. (Windows Solution) The wireless adapter may be disabled. Go to the Start menu, select Control
Panel. Then select Device Manager and locate the Amped Wireless adapter under the Network
Adapters category. Right click the Amped Wireless adapter and check to see if it is disabled. If
disabled, enable the adapter and try to scan for networks again. If there is a problem with the driver,
it will also be displayed here. Check solution (f) to solve this issue.
To Next Page
Loading...
