Need help?Do you have a question about the Ampere Audio AA-150.4 and is the answer not in the manual?
Power Output| RMS power, 4 ohms stereo | 150W x 4CH |
|---|---|
| RMS power, 2 ohms stereo | 225W x 4CH |
| RMS power, 4 ohms bridged | 450W x 2CH |
Audio Performance| Signal To Noise Ratio | >90dB |
|---|---|
| Frequency Response | 10Hz~40KHz (+/- 1dB) |
| Channel Separation | 75dB |
Frequency Crossover| Low Pass Frequency Crossover | 50Hz~5KHz |
|---|---|
| High Pass Frequency Crossover | 50Hz~5KHz |
Electrical Specifications| T.H.D Continuous @ 4 ohm, 1KHz | <0.1% |
|---|---|
| Input Sensitivity | Variable 200mV~8V (+/- 5%) |
| Operating Voltage | DC 8.5V~16V |
Physical Characteristics| Dimensions | 174(W)x52(H)x290(L) mm |
|---|---|
| Recommend Fuse Rating | 30A x 2 |
Prepare for amplifier installation, ensure safety and proper location for cooling and vibration.
Connect +12V, GND, and REM wires. Ensure proper fusing and grounding for safe operation.
Connect inputs and set channel mode for signal processing.
Configure gain, crossovers (HPF/LPF/Subsonic), and filter multipliers for sound tuning.
Diagram and labels for +12V, GND, and REM power connections.
Explains the function of Power (LED) and Protect (LED) indicators.
Details speaker output connections and minimum requirements.
Illustrates +12V, GND, and Remote wiring from head unit and battery.
Recommendations for speaker cable gauge, routing, and connection.
Wiring diagram for connecting speakers in 2 channel bridged mode.
Wiring diagram for connecting speakers in 4 channel stereo mode.
Wiring diagram for connecting speakers in 6 channel tri-mode.
Diagnose issues when the Power LED is off.
Troubleshoot reasons for the Protect LED being on (impedance, thermal, short).
Diagnose and resolve issues with no audio output from the amplifier.
Address turn-on noise and poor bass response issues.
Identify and eliminate engine noise caused by wiring or grounding.
Details RMS power output for various impedances and configurations.
Specifications for frequency response, THD, channel separation, and signal-to-noise ratio.
Specs for input sensitivity, physical dimensions, operating voltage, and recommended fuse rating.
To Next Page