Ampex 351 Series - PORTABLE AND RACK MOUNTING

www.SteamPoweredRadio.Com
A.mpex Series 35 1 Recorder / Reproducer - ¾ View
assembly.
Step 5: Jnsta l1 the electronic assemb l y, tight-
eni.ng the four knurled nuts to fasten
it to the frame.
Step 6: Connect the captive head ca bl es at
th cjr locations on the electronic as-
scm bl y.
Step 7: Connect the captive CABLE TO
ELECTRONICS to
the electronic as -
semb l y.
Step 8: Replace the back panel, making cer-
tain
that all cables run freely through
the semi -c ir cular cut-outs at the bot-
tom
of the sliding panel.
Two Case Por tabl e Mod els
(For 351-2 sec the applicable INT ERCON-
NECT ING illustration at the back of this SEC-
TION).
The two case portable models are s hipp ed
in a ready to operate conclition, except for the
connection of int erco nn ecting cab les. Conven-
ient rubber feet arc located at both ends of
each case , and metal rests arc provided on the
2-2
backs
of each case. To set up the equipment
follow these steps:
Step 1: Arrange the cases so that the mechan-
ical assembly case
is to the right of
the electronic assembly case.
Step 2: Unlatch and remove the top cover
and the side access door on the me-
chanical assembly case.
Step 3: Unlatch and . remove the front and
rear covers on the electronic assembly
case .
Step 4: Uncoil the interconnecting cables
from behind
the cable access door on
the tape transport case and plug them
into
mating receptacles at the rear
of the electronic assemb l y.
Step 5: Connect the a-c power, a nd the input
and output to the rear of the elec-
tronic assembly.
Ra ch layout ( Model 351-2)