AMS RMX16 500 Series User Manual

1
RMX 16: Digital Reverberation System
500 Series Module
User Manual Issue 1

AMS RMX16 500 Series Specifications

General

Format	500 Series
Reverb Algorithms	Hall, Plate, Room, Non-Linear
Controls	Decay
Inputs	1x TRS
Outputs	1x TRS
Output Impedance	100Ω
Frequency Response	20Hz - 20kHz

Summary

Health & Safety Notice

Introduction

System Overview

Installation Diagram

Adjusting Unit Parameters

Pot Control Section

How to use the rotary encoder for parameter adjustments.

Nudge Section

Using UP/DOWN buttons to adjust parameters.

Keypad Entry

Precise parameter input using the alphanumeric keypad.

Operating Instructions: Levels and Mix

Input/output Level Monitoring

Using level LEDs and adjusting input gain.

Adjusting Input, Output, and Mix Levels

Controlling signal gain and dry/wet balance.

Program and Decay Control

Program Selection

How to select from the 18 available reverberation programs.

Decay Time Entry

Methods for setting the decay time parameter.

Pre-Delay Entry

How to adjust the pre-delay time for reverb onset.

Filter and Mix Controls

Decay Filter Controls

Adjusting high and low-frequency decay filter settings.

Mix Control

Balancing the wet and dry signal mix.

Using the RMX 16

Saving and Recalling Presets

Setup Menu

Specifications

Appendix A: Program Details

Program Index and Ambience

Overview of programs and details for Program 1 AMBIENCE.

Program Details: Rooms, Halls, Plates

Programs 2-6 (Room A1, Hall C1, Plate A1, Hall B3, Chorus)

Summarizes programs 2 through 6, their characteristics and uses.

Program Details: Effects and Echo

Programs 7-9 (Echo, Nonlin 2, Reverse 1)

Summarizes programs 7 through 9, their characteristics and uses.

Program Details: Reverses and Freeze

Programs 10-13 (Reverse 2, Freeze, Room A0, Room B1)

Summarizes programs 10 through 13, their characteristics and uses.

Program Details: More Rooms and Effects

Programs 14-17 (Hall A1, Plate B1, Delay, Image P1)

Summarizes programs 14 through 17, their characteristics and uses.

Program 18 NONLIN 1

Appendix B: Frequency Characteristics

High and Low Frequency Decay Characteristics

How frequency profiles affect decay time settings.