1. CONNECT AIRLINE, SET AT 80 PSI.
2. TURN ON SWITCH LOC. IN REAR OF
MACHINE.
3. ADJUST TOP INPUT GUIDE (141) WITH
MATERIAL INSERTED. MATERIAL
MUST BE CENTERED.
4. CLOSE WHEELS W/ADJUSTABLE HAND CRANK.
TOO LOOSE: MATERIAL WILL NOT BE INDEXED
AND SLIP. TOO TIGHT: MATERIAL MAY BE
CRUSHED. MAKE NOTE OF WHEEL POSITION
INDICATOR FOR FUTURE REF.
5. BOTTOM GUIDE 6. ADJUST BOTTOM GUIDE WHEEL APPROX.
¼” ON EACH SIDE OF MATERIAL
7. SLICE KEYPAD SAFETY SHIELD TO LEFT. 8. HIT “LOAD” KEY AND SLIDE KEYPAD
SAFETY SHIELD BACK TO RIGHT.
141 QUICK START GUIDE
*SAFETY: ALWAYS TURN OFF POWER AND DISCONNECT THE AIR LINES BEFORE
INVESTIGATING JAMS OR INTERNALS ISSUES. NEVER PLACE FINGERS, HANDS,
OR TOOLS INTO THE MACHINE WHILE IT IS PLUGGED IN OR AIR CONNECTED.
*BE SURE TO INSTALL TOP AND BOTTOM
CLEAR PLASTIC SAFETY SHIELDS.
BOTTOM SAFETY SHIELD
TOP SAFETY SHIELD
To Next Page
