Firmware Pages and Descriptions
89
NXD-1000Vi 10" Modero® Wall/Flush Mount Touch Panel with Intercom
Refer to the Using the Site Survey tool section on page 42.
Static WEP Settings
Press the Static WEP button to open the Static WEP Settings page (FIG. 75).
Static WEP security requires that both a target WAP be identified and an encryption method be
implemented prior to establishing communication. In addition to providing both Open and Shared
Authentication capabilities, this page also supports Hexadecimal and ASCII keys.
FIG. 75 Wireless Settings page - Static WEP Settings
Static WEP Settings
SSID (Service Set Identifier): Opens an on-screen keyboard to enter the SSID name used on the target
WAP.
The SSID is a unique name used by the WAP, and is assigned to all panels
on that network. An SSID is required by the WAP before the panel is permit-
ted to join the network.
• The SSID is case sensitive and must not exceed 32 characters.
• Make sure this setting is the same for all points in your wireless network.
• NXA-WAP200Gs use AMX as their default SSID.
• If this field is left blank, the panel will attempt to connect to the first available
WAP.
To Next Page
Loading...
