Displaying Stream Content
159
VG Series Modero Touch Panels
10. Click the States tab of the Button Properties Control window to show a list of all states associated with the selected
button. Each state represented in the States tab is a collapsed folder containing the state properties for that particular
state (On/Off/All).
11. Double-click the All States + symbol to expand this folder (FIG. 137) and locate the Video Fill field.
12. Use the Video Fill drop-down arrow to select the Streaming Video option (A in FIG. 137).
13. Within the newly added Streaming Source field, enter the Transport Protocol, IP Address of the MAX-CSE, and
Target Video Port (B in FIG. 137).
When using a UDP Transport Protocol, enter the following into the Streaming Source field: udp://IP Address
of MAX-CSE:Target Video Port set on the UI page.
Our example uses: udp://192.199.99.99:5000
Refer to Step 2: Configuring the MAX-CSE for communication section on page 155. The MAX-CSE is
available from either the front LCD (FIG. 138) or from the IP Settings page of the UI.
When using an RTP Transport Protocol, determine whether you are using an MPEG-2 or MPEG-4 stream and
enter the following into the Streaming Source field: rtpmpeg#://IP Address of MAX-CSE:Target Video Port
Although our example doesn’t use RTP, you could enter the following:
for MPEG-2 rtpmpeg2://192.199.99.99:5000
for MPEG-4 rtpmpeg4://192.199.99.99:5000
FIG. 136 Button Properties tab
FIG. 137 Video Fill - Button Properties setting
FIG. 138 Example of the current display
Button Draw and Selection
tools
Button Properties Control window
(displays information for the
currently active/selected button)
Currently active button
To Next Page
Loading...
