Touch Panel Accessories
15
VG Series Modero Touch Panels
RGB RJ-45 connection and wiring information
This RJ-45 connector is used to route the signals connected to the RGB / Component input port on the rear of the AVB/
RGB Breakout Box to the VG-Series Modero panel. Standard CAT5 cable can be used for this connection with short
cable runs under 50 feet (15.24 m). For cable runs over 50 feet (15.24 m), AMX recommends using the Belden Brilliance
VideoTwist 7987. This Belden cable is not CAT5 compliant, but is designed to control skew between the red, green, and
blue video signals. Therefore, for longer cable runs, the video quality will be much higher using the Belden VideoTwist
7987 cable versus standard CAT5 (or other Ethernet compliant cables). The pinout of this RGB connector is given in the
table below.
The Belden cable only adjusts for RGB skew but may still need to be configured
properly for cable length by using the Cable Variance setting on the RGB Adjustment
page (Video - RGB Settings Page section on page 123).
RGB RJ-45 Connector Pinouts and Signals
Pin Color Function Polarity
1 Orange-White Blue Video -
2 Orange Blue Video +
3 Green-White Data (bidirectional) -
4 Blue Green Video -
5 Blue-White Green Video +
6 Green Data (bidirectional) +
7 Brown-White Red Video -
8 Brown Red Video +
It is important that the correct pairing is observed.
To Next Page
Loading...
