AMX NXD-1200VG - NXA-MTC;RGB Combo Table Top Cable (CA2250-70); Product Specifications

Touch Panel Accessories
21
VG Series Modero Touch Panels
NXA-MTC/RGB Combo Table Top Cable (CA2250-70)
The VG-Series of Modero Touch Panels (fitted with either an RGB Kit (Video/RGB) or upgraded with an optional NXA-
RGBKIT (FG2255-11)) are shipped with a 10' (3.048 m) NXA-MTC/RGB Modero cable (CA2250-70) that supports
both RGB, Ethernet, Audio/Video, and Power connections. This cable (FIG. 8) comes terminated with three RJ45
connectors (Ethernet/AV/RGB) and a single 2-pin 3.5 mm mini-Phoenix connector (for power).
Product Specifications
FIG. 8 10 Foot NXA-MTC/RGB Combo Table Top Cable
NXA-MTC/RGB Specifications
Dimensions (HWD): • Length: 10 feet (3.048 m)
Connectors: • Ethernet RJ-45 connector (White) routes Ethernet signals between the touch panel
and the AVB/RGB Breakout Box.
• Audio/Video RJ-45 connector (Black) routes differential audio/video signals between
the touch panel and the box.
• RGB RJ-45 connector (Blue) routes RGB/Component video signals and touch
control information to the RJ-45 RGB connector on the NXA-RGB card (installed
within the panel). This connector routes VGA and Component video signals between
the panel and the AVB/RGB Breakout Box.
• 2-pin 3.5 mm mini-Phoenix power connector to route power from the external
breakout box to the target panel.
Included Accessories: • One NXA-MTC/RGB Combo Table Top Cable (CA2250-70)
• One black tie wrap (used to join the Ethernet and Power cables)
Other AMX Equipment: Note: All 1200V, VG-Series, and CV10 Table Top panels routing an Audio/Video signal
from a breakout box must use the appropriate number of CAT5 Suppression Ferrites
which are included as part of installation kits accompanying your particular Modero panel.
Each of the following Installation Kits come with the appropriate number of CAT5
Suppression Ferrites.
These ferrites must be installed onto their appropriate locations.
• Installation Kit for 12" and 17" NXD panels (KA2251-01):
- 2-pin mini-Phoenix connector (41-5025)
- Three Phillips-head screws (#4-20 x 0.250 Black) (80-0114-08)
- One CAT5 Suppression Ferrites (04-0014)
- Four Drywall clips (62-5924-05) and #6 -metal strips (80-0192)
• Installation Kit for 15" NXD panels (KA2251-02):
- 2-pin mini-Phoenix connector (41-5025)
- Three Phillips-head screws (#4-20 x 0.250 Black) (80-0114-08)
- Two CAT5 Suppression Ferrites (04-0014)
- Four Drywall clips (62-5924-05) and #6 -metal strips (80-0192)