Touch Panel Accessories
36
VG Series Modero Touch Panels
Step 5: Close and Resecure the NXD Panel Enclosure
1.
With the components securely installed, gently place the outer housing back onto the metallic panel casing (with the
connector opening on the right-side of the panel) and align the four pan-head Housing Screw holes along the edges
of the outer housing.
2. Insert and secure the four pan-head Housing Screws into the pre-drilled holes along the edges of the NXD unit by
using a grounded Phillips-head screwdriver.
3. Remove the previous I/O plate adhesive overlay (this reveals a pre-drilled RGB connector opening) and replace it
with the new adhesive RGB overlay (53-2250-03).
4. Reinstall the upgraded RGB I/O connector plate by aligning all connectors to their respective locations (FIG. 24).
5. Secure the I/O plate using a grounded Phillips-head screwdriver and then twist the Stereo Output nut back onto the
Stereo Output jack.
FIG. 23 Location of the Compact Flash card and I/O plate on NXD
Outer Housing
Compact Flash card
I/O connector
plate
NXA-PCI80211G
wireless card
location
Four Pan-head
Housing
Screws
Use care not to bend or damage any antenna connections while replacing the outer
housing.
FIG. 24 NXD I/O plate with upgraded RGB overlay
To Next Page
Loading...
