AMX NXD-1200VG - Product Specifications; Checking the NXT-BP Battery Charge; Installing the NXA-BASE;B to an NXT Modero Panel

Touch Panel Accessories
38
VG Series Modero Touch Panels
Product Specifications
Checking the NXT-BP battery charge
1.
Press the Battery Life Indicator button (FIG. 27) once to illuminate the Battery Life LEDs and display the percent
charge remaining on the battery (this indication lasts a few seconds).
2. Repeat the above step for each NXT-BP battery.
3. Charge the NXT-BP battery by either inserting it into the battery base or from within the optional NXT-CHG
charger (which can sequentially charge up to two batteries).
Installing the NXA-BASE/B to an NXT Modero Panel
The battery base must be installed onto the NXT panel without any NXT-BP batteries.
1. Power Off the panel before attempting to use the NXA-BASE/B.
2. Place the empty battery base onto a flat/level surface.
3. Verify the alignment of the Panel Interface connectors between the panel (male connector) and base (female
connector) (FIG. 28).
NXA-BASE/B Specifications
Dimensions (HWD): • 1.13" x 8.63" x 11.81" (2.86 cm x 21.91 cm x 30.00 cm)
Power Requirements: • 2.7 A @ 12 VDC (max power draw while charging)
Weight: • Base unit: 1.25 lbs (0.567 kg)
• Base and 2 batteries: 3.23 lbs (1.47 kg)
Features: • Charge time for two depleted batteries ~ 5 - 8 hours (when NXT panel is in Sleep mode)
• Must be connected to the Modero unit utilizing a 12 VDC-compliant power supply
Operating / Storage
Environment:
• Operating Temperature: 0° C (32° F) to 40° C (104° F)
• Operating Humidity: 20% - 85% RH
• Storage Temperature: -20° C (-4° F) to 60° C (140° F)
• Storage Humidity: 5% - 85% RH
Other AMX Equipment: • NXT-CHG Kit (FG2250-50K):
1 charger (FG2250-50) and 2 NXT-BP batteries (FG2255-10)
• NXT-BP battery pack (FG2255-10)
• NXT-CHG battery charger (FG2250-50)
It is recommended to fully charge the batteries before their initial use.
FIG. 27 NXT-BP (showing Battery Life Indicator button and charge)
Battery Life Indicator button
Battery Life (Charge) Display
If the 25% LED is blinking, this indicates there is less than 5% of a charge remaining
on the battery.