Touch Panel Accessories
40
VG Series Modero Touch Panels
9. Secure each captive fastener head using a grounded flat-head screwdriver until the NXA-BASE/B is securely
attached to the underside of the NXT Modero touch panel.
10. Firmly grip the panel LCD/base combo and gently rotate the unit back onto the base.
Installing an NXT-BP into the NXA-BASE/B
The battery base does not directly connect to a power supply, but rather receives its power directly from the Modero
panel, through the Panel Interface connector.
1. With the panel mounted on the battery base, open the battery compartment (FIG. 30) by pulling the handle
outwards. This compartment houses two NXT-BP batteries.
2. Install the NXT-BP battery. label-side down.
3. Align the battery connectors with the corresponding battery connector port (located inside the battery
compartment), as shown in FIG. 30.
4. Insert the NXT-BP battery until the connectors securely fit into the battery connector port.
5. Repeat steps 2 through 4 for the other battery.
6. Apply a small amount of pressure to close the battery compartment until the compartment latches.
After a few seconds, the panel will turn On and the AMX logo will appear (indicating the panel is receiving
power.
Charging the NXT-BP batteries with the NXA-BASE/B
1.
Follow the procedures from the previous sub-section to attach the NXT touch panel to the NXA-BASE/B.
2. Insert each battery into the battery compartment shown in FIG. 30.
3. Insert a 2-pin connector from a power supply to the rear PWR connector on the NXT Modero panel.
The charge status bargraph indicators, on the Battery Base page, indicate when the batteries are fully charged.
Remove any connectors from the rear of the Modero NXT panel before continuing
with the installation of the batteries. Power can only be supplied after the batteries
have been installed.
FIG. 30 Battery installation procedure
Battery
Compartment
NXT-BP Battery #2
Battery
Connectors
Battery
Connector
Port
Interface
connector
FRONT
NXT-BP Battery #1
Battery #2
slot
The NXA-BASE/B will only charge batteries when the NXT panel is in Sleep mode.
To Next Page
Loading...
