Displaying Stream Content
138
Modero VG Series Touch Panels - Instruction Manual
11. Double-click the All States + symbol to expand this folder (FIG. 137) and locate the Video Fill field.
12. Use the Video Fill drop-down arrow to select the Streaming Video option (A in FIG. 137).
13. Within the newly added Streaming Source field, enter the Transport Protocol, IP Address of the MAX-CSE, and Target Video
Port (B in FIG. 137).
When using a UDP Transport Protocol, enter the following into the Streaming Source field: udp://IP Address of MAX-
CSE:Target Video Port set on the UI page.
Our example uses: udp://192.199.99.99:5000
Refer to Step 2: Configuring the MAX-CSE for communication section on page 134. The MAX-CSE is available from either the
front LCD (FIG. 138) or from the IP Settings page of the UI.
When using an RTP Transport Protocol, determine whether you are using an MPEG-2 or MPEG-4 stream and enter the
following into the Streaming Source field: rtpmpeg#://IP Address of MAX-CSE:Target Video Port
Although our example doesn’t use RTP, you could enter the following:
for MPEG-2 rtpmpeg2://192.199.99.99:5000
for MPEG-4 rtpmpeg4://192.199.99.99:5000
NOTE: Modero doesn’t require that an audio port be entered within the Streaming Source f ield because the firmware already
assumes the audio port value to be 2 greater than the value set for the video port.
14. Create buttons on both this project’s main page and within this Video page which can allow the user to navigate between both
pages.
15. Save these pages, and after establishing a connection, upload this project to the target Modero panel.
Step 5: Establishing the f inal connection between the two units
1. Start playing the media at its source (DVD, VCR, camera, etc.)
2. While in the UI pages (log back in if not already connected), navigate to the Administration page by clicking on the Admin link
from the left Navigation frame.
3. Locate the Mode section of this page and click the Play button to begin streaming the incoming media content to the targeted
Modero panel. For these procedures, the Program information is optional and not "picked-up" by the panel.
4. With the panel now loaded with the new TPD4 project containing the streaming media page/popup/button, navigate from the
initially displayed (main) page to the page containing the Streaming Video Fill button which we created in the previous step. It
should now be displaying the audio and video from the incoming stream.
If the audio level is not sufficient, you can either go back and create a volume control button or go to the Modero’s Audio
firmware page and adjust the value assigned to the Master Volume for the panel.
If there is no video being displayed on the page:
Navigate to the firmware pages by pressing the grey Front Setup Access button for 3 seconds to open the Setup page and
then press the on-screen Video Adjustment button, causing an option bar to slide outwards from the Navigation buttons.
Click on the Streaming Adjustment button to launch the Streaming Video Settings page and confirm that the panel is at
least receiving the signal (FIG. 139).
FIG. 137
Video Fill - Button Properties setting
FIG. 138 Example of the current display
To Next Page
Loading...
