Touch Panel Accessories
42
Modero VG Series Touch Panels - Instruction Manual
2. Install the NXT-BP battery. label-side down.
3. Align the battery connectors with the corresponding battery connector port (located inside the battery compartment), as
shown in FIG. 30.
4. Insert the NXT-BP battery until the connectors securely fit into the battery connector port.
5. Repeat steps 2 through 4 for the other battery.
6. Apply a small amount of pressure to close the battery compartment until the compartment latches.
After a few seconds, the panel will turn On and the AMX logo will appear (indicating the panel is receiving power.
Charging the NXT-BP Batteries With the NXA-BASE/B
1. Follow the procedures from the previous sub-section to attach the NXT touch panel to the NXA-BASE/B.
2. Insert each battery into the battery compartment shown in FIG. 30.
3. Insert a 2-pin connector from a power supply to the rear PWR connector on the NXT Modero panel.
The charge status bargraph indicators, on the Battery Base page, indicate when the batteries are fully charged.
NOTE: The NXA-BASE/B will only charge batteries when the NXT panel is in Sleep mode.
NXT-CHG Battery Charger Kit (FG2255-50K)
The NXT-CHG Kit includes one charger and two batteries. The optional NXT-CHG Modero Power Station (FIG. 31) is a two-slot,
stand-alone battery charger that can be used to recharge up to two NXT-BP batteries. The batteries are charged in the order they
are inserted into the charger. The NXT-CHG Slot 1 has the feature of being able to completely discharge and recharge (recalibrate)
a battery.
Product Specifications
The batteries are charged in the order they are inserted into the NXT-CHG. SLOT 1 of the NXT-CHG has the ability to completely
discharge and recharge (recalibrate) a battery.
NOTE: Recalibration improves the reporting accuracy of the battery charge back to the Modero panel.
Powering the NXT-CHG
The NXT-CHG Smart Battery Charger uses an included power supply to charge inserted batteries.
1. Connect the rear of the NXT-CHG to the power adapter.
2. Connect the power adapter to the provided power cord (with plug).
3. Provide power to the unit by connecting the power cord (with plug) into a power outlet that meets the requirements outlined
in the Specif ications section for the NXT-CHG.
FIG. 31
NXT-CHG Kit (consists of one NXT-CHG charger and two NXT-BP batteries)
NXT-BP and NXT-CHG Specifications
Dimensions (HWD): • 1.13" x 8.63" x 11.81" (2.86 cm x 21.91 cm x 30.00 cm)
Power Requirements: • NXT-BP Battery Voltage - 11.1 Volts
• NXT-CHG: 90 - 264 VAC, 47-63 Hz, Single Phase (using the included 24 VDC power supply)
Weight: • 0.57 lbs (0.26 kg)
Features: • Charge time for two depleted batteries: ~ 5 hours
• Charge Rate: 2.5 A @ 12 VDC
• 2-Bays: Sequential charging
• LED: One LED indicator in front of each bay which conveys the status of that bay. Refer to the Reading NXT-CHG
LED Indicator section for more information.
• Recalibration pushbutton (located between the bays): Initiates recalibration sequence in the left bay only.
• Recalibration Time: less than 9 hours
Other AMX Equipment: • NXT-BP battery pack (FG2255-10) (additional)
NXT-CHG Modero Power Station (charger)
NXT-BP Modero Power Pack (battery)
Battery Life indicator
To Next Page
Loading...
