AMX NXD-1700VG - Wiring Guidelines for the 1200 VG and 1500 VG Panels; Preparing Captive Wires; Wiring a Power Connection; Audio;Video Port: Connections and Wiring

Installation Procedures: 12" and 15" Panels
56
Modero VG Series Touch Panels - Instruction Manual
Wiring Guidelines for the 1200VG and 1500VG Panels
These Modero panels use a 12 VDC-compliant power supply to provide power to the panel via the 2-pin 3.5 mm mini-Phoenix PWR
connector. Use the previously referenced power requirements to determine the power draw. The incoming PWR and GND wires from
the power supply must be connected to the corresponding locations within the PWR connector.
NOTE: These units should only have one source of incoming power. Using more than one source of power to the touch panel can
result in damage to the internal components and a possible burn out. Apply power to the panels only after installation is complete.
Preparing Captive Wires
You will need a wire stripper and flat-blade screwdriver to prepare and connect the captive wires.
NOTE: Never pre-tin wires for compression-type connections.
1. Strip 0.25 inch (6.35 mm) of insulation off all wires.
2. Insert each wire into the appropriate opening on the connector (according to the wiring diagrams and connector types
described in this section).
3. Tighten the screws to secure the wire in the connector. Do not tighten the screws excessively; doing so may strip the threads
and damage the connector.
Wiring a power connection
To use the 2-pin 3.5 mm mini-Phoenix connector with a 12 VDC-compliant power supply, the incoming PWR and GND wires from
the external source must be connected to their corresponding locations on the connector (FIG. 48).
1. Insert the PWR and GND wires on the terminal end of the 2-pin 3.5 mm mini-Phoenix cable. Match the wiring locations of the
+/- on both the power supply and the terminal connector.
2. Tighten the clamp to secure the two wires. Do not tighten the screws excessively; doing so may strip the threads and damage
the connector.
3. Verify the connection of the 2-pin 3.5 mm mini-Phoenix to the power supply.
Audio/Video Port: Connections and Wiring
The following table shows the signal and pinout/pairing information used on the RJ-45 Audio and Video connections.
Refer to the Installing CAT5 Suppression Ferrites section on page 28 for detailed information on how to install the necessary
number of CAT5 Suppression Ferrites on the Black A/V RJ-45 cable connected to the panel.
FIG. 48
NetLinx power connector wiring diagram
Audio/Video RJ-45 Pinout Information
Pin Wire Color Function Polarity
1 Orange/White Right Audio In +
2 Orange Right Audio In -
3 Green/White Video In -
4Blue Mic Out -
5White/Blue Mic Out +
6 Green Video In +
7 White/Brown Left Audio In +
8 Brown Left Audio In -
PWR +
GND -
To the Touch Panel
Power Supply
TIA 568B
1
2
3
4
5
6
7
8
1 2 3 4 5 6 7 8
RJ-45 connector - pin configurations
(female) (male)