Installation Procedures: 17" Panels
59
Modero VG Series Touch Panels - Instruction Manual
NOTE: DO NOT REMOVE THE FOUR PANEL SECURING SCREWS. These screws secure the LCD to the metallic casing underneath.
7. Lift the back box housing to separate it from the internal panel casing.
Installing the MP-TP17 Back Box
1. Unscrew the four pan-head Housing Screws (#8-32) from the MB-TP17 rear plastic cover.
2. Gently place the MB-TP17 back box over the internal panel casing (with the cable routing hole on the right-side of the panel).
3. Re-install and secure the four pan-head Housing Screws into their pre-drilled holes along the edges of the MB-TP17 back box
(FIG. 51) and secure them using a grounded Phillips-head screwdriver.
4. Place the I/O connector plate back over the connector opening and align the connector locations.
5. Resecure the I/O connector plate (using a grounded Phillips-head screwdriver) and resecure the Stereo Output nut on the
Stereo Output jack.
Cable Installation for the MP-TP17 Back Box
1. Connect the cable connectors (RJ-45, Ethernet, and any other audio/video wiring) to their respective locations along the side
of the touch panel.
2. Use the tie-wrap (45-0009A) to wrap the cables together inside the VESA Mount enclosure. This cable tie is used to insure the
cable will not pull through or work itself through the new larger strain relief grommet (45-0032-01) over time.
3. Thread the incoming cables through the hole on the rear plastic cover and then through the strain relief grommet.
4. Slide the grommet along the cable and securely insert it into the opening on the rear plastic cover (FIG. 51).
Finalizing the Installation
1. Gently place the rear plastic cover over the NXD panel (with LCD and MB-TP17 back box).
2. Insert the protruding cables, coming out from the opening on the rear plastic cover, into the open strain relief grommet.
3. Allow some slack/length on these cables as a service loop. This service loop provides enough cable length so you can later
remove the NXD (with connected cables) from the rear plastic cover.
NOTE: VERIFY THE LENGTH AND LOCATION OF THE INSERTED CABLES. ONCE THE STRAIN RELIEF GROMMET IS CLOSED, IT IS
DIFFICULT TO RE-OPEN.
4. Carefully apply pressure to close the strain relief grommet over the desired cable location.
FIG. 51
Location of the attachment screws on the NXD back box and VESA housing
Four (#8-32) screws
Internal panel casing
MB-TP17 back box
Ten
Rear plastic cover
(60-0033-50)
Connector
Four (pan-head) Housing Screws
Securing
(62-0033-50)
Strain relief grommet (Clip facing up)
Rim of the strain relief grommet
should lie flush against enclosure
opening
hole locations
(2 on each side)
securing
DO NOT REMOVE
screws
#6-32
To Next Page
Loading...
