AMX NXD-700i - ?Phn-Privacy; Phn-Setup-Domain; Phn-Setup-Enable; Phn-Linestate

Programming
124
NXD-700i & NXT-CA7 7” Modero Touch Panels
The following table lists and describes SIP setup commands. Using any of these commands causes the current
user to go offline.
SIP Commands (Cont.)
?PHN-LINESTATE Queries the state of each of the connections used by the SIP device.
The panel responds with the ^PHN-LINESTATE message.
Syntax:
"’?PHN-LINESTATE’"
Example:
SEND_COMMAND Panel,"'?PHN-LINESTATE'"
^PHN-PRIVACY Enables or disables the privacy feature on the phone (do not disturb).
Syntax:
"’^PHN-PRIVACY, <state>’"
Variable:
state = 0 (Disable) or 1 (Enable)
Example:
SEND_COMMAND Panel,"'^PHN-PRIVACY, 1'"
Enables the privacy feature.
?PHN-PRIVACY Queries the state of the privacy feature.
The panel responds with the ^PHN-PRIVACY, <state> message.
Syntax:
"’?PHN-PRIVACY’"
Example:
SEND_COMMAND Panel,"'?PHN-PRIVACY'"
^PHN-REDIAL Redials the last number.
Syntax:
"’^PHN-REDIAL’"
Example:
SEND_COMMAND Panel,"'^PHN-REDIAL'"
^PHN-TRANSFER Transfers the call to the provided number.
Syntax:
"’^PHN-TRANSFER, <connection id>, <number>’"
Variable:
connection id = The identifying number of the connection
number = The number to which you want to transfer the call.
Example:
SEND_COMMAND Panel,"'^PHN-TRANSFER, 1, 2125551000'"
SIP Setup Commands
^PHN-SETUP-DOMAIN Sets the realm for authentication.
Syntax:
"’^PHN-SETUP-DOMAIN,<domain>’"
Variable:
domain = The realm used for authentication
Example:
SEND_COMMAND Panel,"’^PHN-SETUP-DOMAIN,asterisk’"
^PHN-SETUP-ENABLE Registers a new user
Once the configuration has been updated, the ENABLE command should be
run to re-register the new user.
Syntax:
"’^PHN-SETUP-ENABLE’"