AMYET S8 - Page 25

AMYET
S8 E-bike
CHARGING AND BATTERY ATTENTION
Charging Instructions
1. Find the battery charging port (near the battery compartment' s
key port).
2. First, connect the output plug of the charger with the charging
port of the bicycle properly, and then connect the input plug of
the charger to the power socket.
3. When the red LED indicator light turns green, it indicates that
the battery is fully charged.
4. After charging, first, pull out the plug from the power socket,
and then disconnect the charger from the charging port.
Attentions about the Battery
1. Charge the battery before the first ride. Depending on the ambient
temperature and remaining power, it may take 2 to 9 hours.
2. Do not charge the battery when the temperature is lower than
OOCor higher than 400C. If higher than 400C, this may lead to
battery failure and oven a fire.
3. Ensure that the power supply voltage is 220/240V. Do NOT plug
the charger into the power supply of different voltage.
4. Charge the battery after each ride to ensure sufficient power for
the next ride.
5. Charge the battery at least once a month when you are not
using theelectric bicycle.
6. Store the battery in a place higher than OOCin winter.
7. Avoid deep discharge of the battery.
8. Do not charge the battery for more than 24 hours, which may
23