AMYET
INSPECTION INSTRUCTIONS
S8 E-bike
1. Check the tension of the chain and spokes to make sure there is
no noise or loosening.
2. Ensure that all mechanical components can work normally, i.e.,
wheels, pedals and handlebars turn freely without unnecessary
noise.
3. Ensure all the parts that need to be tightened have been correctly
tightened, such as frame, handlebar, seat post, etc.
4. The distance between the brake lever and the handlebar must
be atleast 15mm when you press the front and rear brake lever
to completely stop the wheels.
5. Keep throttle rotating in a proper range and achieve progressive
motor traction control.
O NOTES AND CAUTIONS
1. Avoid direct contact with water. If water enters, please wipe up
the water and put the electric bicycle in a dry, airy place as soon
as possible.Then, open the frame-integrated control module and
switch compartment (29), frame and handlebar clamp until the
water completely evaporates. Do NOT charge the battery until
the water has completely evaporated.
2. Check the wear and damage of the electric bicycle and
component loss regularly.
3. Check the fastening of each nut every 100 km.
4. As sprockets, gears, tires, grips, brake pads, etc., are consumables
with limited-service life, please check them regularly and replace
them in time to keep riding safe and efficient.
25
To Next Page
Loading...