EasyManua.ls Logo

Analogic 2020 - Page 6

Analogic 2020
6 pages
Print Icon
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Maximum Waveform LengthDynamic (Repeat) Looping, up to 32,767 times, and 512k data points
DCdata compression for waveforms exceeding (2048k, B version)
output memory length
Minimum Waveform Length8 Data points on Version 25 64 Data points
16 Data points on Version 100
Waveform Equation Memory30 kbytes non-volatile, expandable to 78k 78 kbytes non-volatile
(Stores waveform 1280 characters maximum file length 1280 characters maximum file length
descriptions by filename)
Waveform Equation Memory Retention: >2 years with supplied lithium batteries and a 50% power-on duty cycle
Memory Retention (provision is made for field replacement with more conventional Alkaline batteries)
AUXILIARY INPUTS/OUTPUTS (Menu driven setup)
External Clock Input DCto max. update rate of version DCto 800 MHz update rate
External Trigger Input Trigger Modes: Free Run, Manual, Triggered Start, Trigger Modes: Free Run, Manual, Triggered Start,
Triggered Stop, Gated by Trigger, and Triggered Triggered Stop, Gated by Trigger, and Triggered
Start/Stop Start/Stop; Delay: < (40 ns + 2 clock periods); Jitter:
Delay: < 100 ns +1 clock period < (100 ps + 1 clock period).
Jitter: < 10 ns
Trigger and External Clock Threshold: 0V or 1V; Slope: plus or minus; Threshold: 0V or 1.5V; Slope: plus or minus;
Input Parameters Impedance: 1 M|| 25 pF; Sensitivity: ±500mV Impedance: 10 k|| 50 pF; Sensitivity: ±500 mV
about selected threshold; Maximum input: ±30V; about selected threshold; Maximum input: ±30V;
Marker Output Negative transition at waveform start, positive Positive pulse at user selected Mark Time or Mark
transition at Mark Time or Mark Count (TTL, Count from start of waveform; Pulse duration:
10 unit loads) 32 data point clocks (TTL, drives a grounded 50load)
Sync Output Positive pulse at waveform start (TTL, 10 unit loads) Positive pulse at waveform start; Pulse duration: 32 data
point clocksTTL, drives a grounded 50load)
Multi-Unit Synchronization Via phase locked internal clocks and ganged trigger Via auxiliary inputs and outputs
functions in a Master/Slave configuration, up to 8
units, with rear panel adjustments for cable delays
Digital Waveform Output 16 bits plus clock, simultaneous with Analog Output;
TTL on Version 25; ECL (diff.) on Version 100 (opt.)
REMOTE INSTRUMENT CONTROL
Interface Optional IEEE-488 and/or RS-232 Standard IEEE-488 and RS-232
Transfer Data Rates IEEE-488: 2 kbytes/s standard IEEE-488: 300 kbytes/s using High Speed DMA
300 kbytes/s with High Speed DMA opt. RS-232: up to 9600 baud
RS-232: up to 9600 baud
WAVEFORM GENERATION MODES
Mathematical By Front Panel entry or by remote communications
(Polynomial) Notation
Standard Functions By Front Panel entry or by remote communications: Standard Functions include sine wave,
square wave, pulse, triangle, sawtooth, and random noise
Internal Noise Source Pseudo-random white noise with a normal Random noise with approx. normal amplitude
amplitude distribution; Cycle time: 168 seconds distribution can be added to waveforms in memory,
Bandwidth: 0.006 Hz to selectable 20 kHz, 200 kHz, with selectable noise amplitude, bandwidth, seed
or 2 MHz; Maximum Amplitude (RMS): 2.7V for 2 MHz(starting point), and signal+noise amplitude. Signal
BW, 0.95V for 200 kHz BW, 0.31V for 20 kHz BW may be repeated in memory so different noise
Amplitude range: 60 dB in 1 dB steps values occur over each signal cycle.
Direct Waveform Data Via IEEE-488 or RS-232
Download
Captured Data ReproductionWith Analogic Model 6100 or 6500 Waveform Analyzer (except Model 2000)
Scope Draw with Cursor For point by point waveform editing
Control
GENERAL
Specification Conditions 0 to 40°C operating temperature; 50resistive termination on both analog outputs, unless specified otherwise;
Open circuit output will double (±5%) in amplitude, but with some degradation in high frequency/speed perfor-
mance
Power Requirements 90-130 VACor 180-260 VACat 48-62 Hz; 90-130 VACor 180-260 VACat 48-62 Hz; 200W max
100W max
Dimensions 5.5"H x 16.5"W x 17"D (13.97 x 41.91 x 43.18 cm) 5.5"H x 16.5"W x 17"D (13.97 x 41.91 x 43.18 cm)
Weight 25 lb (11.3 kg) 25 lb (11.3 kg)

Related product manuals