Description:
1 – Carrying handle
2 – Removable top cover
3 – Cover attachment
Keeps the cover in place. This can be removed to access the internal parts of the
boat.
4 – Front lighting.
6 white leds – high visibility
5 – Rear lighting.
2 red leds – high visibility
6 – Place for ON/OFF switch for ALF100 fish finder (optional)
7 – Screwing point for ALF100 fish finder antenna (optional)
8 – Rear line dropper
The rear line release is able to carry 1 line.
9 – Main batteries compartment
The two lithium batteries 7.4V/ 12 Ah are located on each side of the hull.
10 – Bait hoppers
Contain your baits for a maximum weight of 5kg (2 x 2.5 kg). The hoppers opening
and closing is controlled by 2 separated potentiometers on the RC handset.
11 – Bait hopper servomotors
Open and close the flaps of the bait container. The bait hopper is split in 2 parts
operating each with its own servomotor.
12 – Motors
One motor on each side of the boat. It offers the power to the boat.
13 – Greaser tube on the propeller axis
Connect here the grease bomb to lubricate the driving shaft.
14 – Speed controllers
Each is driving a motor with proportionality with the gas stick on the RC handset.
15 – Fuses
The 2 fuses protect the 2 speed controllers from overheat in case the propeller gets
stuck.
16 – Radio receiver
Receive the radio signal from the RC handset and distribute the commands to all the
boat’s components.
To Next Page
Loading...