Concerning the removal of lines, the boat is equipped with an ingenious system for
transporting and dropping mounts easily and reliably.
Removal and installation is very precise.
Procedure:
- Reassemble the flexible rod that goes inside the linkage.
- Place the loop of the swivel bottom line on the same stem. (For convenience, it is
advisable to use swivels ring).
- Cover all with the rubber cap.
- Attach the magnet on the hook for this purpose. (This will help the bottom line to
stay out of the water during transporting into position).
At the desired location, simply activate the command to dump the line.
Note that it is also possible to change the bottom line in the hatch underneath. It will
be dropped at the same time as the bait is discharged.
For all operations relating to the dropping of lines or baiting, it is advised to try on dry
land first to ensure that all is functioning correctly.
Lighting
For use at night or in bad weather, the MAXBOAT is equipped with 6 ultra powerful
white LEDs in the front and 2 rear red LEDs for identifying the position of the boat,
even at a great distance.
In general, the brightness or intensity of the LEDs shows how much control you have
over the boat. If the boat deviates from the intended path, the intensity of the LEDs
will diminish.
Terms of use and precautions
Waterproof
Inside the boat, the electronic components are protected from moisture.
Make sure water does not enter the hull in large quantities or is submerged as the
To Next Page
Loading...