Safety Precautions and Warnings
To avoid injury or damage to the vehicle and/or scan tool, first
read this manual and observe the following safety precautions
when working on a vehicle:
• First, turn off the ignition. Connect the 16-pin connector, and then
turn on the ignition. Always perform vehicle tests in a safe environ
ment.
Do not attempt to operate or observe the device while driving a
vehicle.
• Operating or observing the device distracts the driver and may
result in a fatal accident
Wear safety glasses that meet the standards of ANSI.
Keep clothing, hair, hands, tools, test equipment, etc. away from
all moving or hot engine parts
Operate the vehicle in a well-ventilated area: exhaust fumes are
toxic.
• Place blocks in front of the drive wheels and never leave the
vehicle unattended while performing tests
Use extreme caution when working near the ignition coil,
distributor cap, ignition wires and spark plugs. These components
generate dangerous voltages when the engine is running
Keep a fire extinguisher nearby that is suitable for gasoline,
chemical, and electrical fires.
Keep the scan tool dry, clean, and free of oil/water or grease. If
necessary, use a mild detergent on a clean cloth to clean the
outside of the scan tool
Instructions Manual
I) Turn on the vehicle ignition;
2) Locate the vehicle's 16-pin Data Link Connector (DLC);
3) Connect the device to the vehicle's 16-pin Data Link Connector,
do not use USB to power devices;
4) Start using your device
EN
To Next Page
Loading...