5
OPERATING INSTRUCTIONS
CHARGING SHAVER
This battery charger is intended for use with Andis model FS-1 lithium-ion battery
with a rated capacity of 3.7V 2.8 Wh. Remove the shaver and AC adapter from the
carton. Plug the adapter into a 100/240V AC outlet, or according to your local power
standards. Note that the shaver ON/OFF power switch must be in the OFF position for
the battery to charge. Plug the cord adapter directly into the inlet on bottom of
shaver (Figure A). The green charging indicator light on the shaver will turn on. The
shaver has not been charged at the factory. Please charge the shaver for 2
hours before the first use for maximum performance. You can keep the shaver
plugged into the adapter when not in use. The adapter will maintain the battery at
full charge and the green charging indicator light will stay on. The adapter should be
unplugged if the shaver won’t be used for seven or more days.
WARNING: For the purposes of recharging the battery, only use the detachable
supply unit provided with this appliance. Use only with supply unit, model
designation ZD5C050100USW.
FAILURE TO CHARGE
1. Make sure voltage is present at the wall outlet (confirm with an appliance you
know is working).
2. Check to make sure adapter cord is plugged firmly into shaver. Twist the adapter
connector slightly to insure good electrical connection. If failure to charge still
exists, return shaver to Andis or an Andis Authorized Service Station for
examination and repair or replacement.
USE WITH CORD ADAPTER
If the shaver powers OFF while in use, the power cord can be attached to continue
use in corded operation (Figure A). When the shaver is running with the power cord
attached, the green charging indicator light will remain off, even if the battery is
partially or fully discharged. The shaver will not charge while in use with the cord
attached.
This power unit is intended to be correctly orientated in a vertical or floor
mount position.
To Next Page
Loading...
Need help?
General
