only recharging transformer plug into clipper receptacle.
8. Do not use outdoors or operate where aerosol (spray)
products are being used or where oxygen is being
administered.
9. Do not use this appliance with a damaged or broken blade
or comb, as injury to the skin may occur.
disconnect turn control to OFF then remove plug from
outlet.
11. WARNING: During use, do not place or leave appliance
where it may be 1) damaged by an animal or 2) exposed to
the weather.
12. The battery in this clipper is designed to provide maximum
trouble-free life. However, like all batteries, it will eventually
wear out. Do not disassemble clipper and attempt to
replace battery.
13. Batteries can be harmful to the environment if disposed of
collection. Contact your local government about disposal
practices in your area.
14. When discarding old batteries, cover battery terminals
with heavy-duty adhesive tape to prevent short circuits.
WARNING: Do not attempt to destroy or disassemble
clipper or remove any of its components. Also, never
touch metal terminals with metal objects and/or body
parts, as short circuit may result. Keep away from
children. Failure to comply with these warnings could
result in re or serious injury.
15. This appliance is only to be used with the power supply unit
provided with the appliance.
16. This appliance is only supplied at safety extra low voltage
corresponding to the marking on the appliance.
17. This appliance contains batteries that are only replaceable
by skilled persons.
18. Keep the appliance dry.
SAVE THESE INSTRUCTIONS
UNIVERSAL AC/DC POWER ADAPTER
The unit/charging stand is equipped with a universal AC/DC power adapter. Interchangeable input plugs are
included for use in most countries around the world (Figures A-F). Plugs may vary by model.
REMOVING INPUT PLUG:
1. Unplug AC/DC power adapter from wall outlet.
2. While pressing down on button located on input plug, gently push up on plug until it releases from
power adapter.
REPLACING INPUT PLUG:
1. To replace input plug, align tabs on the AC/DC power adapter with slots on input plug (Figure G).
2. Gently push input plug into power adapter until it snaps into place.
To Next Page
Loading...
Need help?
General
