3. Do not expose this car charger to rain, moisture, or snow.
4. Use of an attachment not recommended or sold by this car charger manufacturer may result in a risk of fire,
electric shock, or injury to persons.
5. To reduce risk of damage to cigarette lighter connector and cord, pull by cigarette lighter connector rather than
cord when disconnecting this car charger.
6. Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or
stress.
7. Do not operate this car charger with damaged cord or cigarette lighter connector – replace it immediately.
8. Do not operate this car charger if it has received a sharp blow, been dropped, or otherwise damaged in any
way; take it to a qualified serviceperson.
9. Do not disassemble this car charger; take it to a qualified serviceperson when service or repair is required.
Incorrect reassembly may result in a risk of electric shock or fire.
10. To reduce risk of electric shock, unplug this car charger before attempting any maintenance or cleaning.
Turning off controls will not reduce this risk.
11. To reduce the risk of fire or electric shock, do not interconnect output terminations.
12. CAUTION
For continued protection against risk of fire, replace only using fuses of the same type and rating: fuse
rating 32Vdc, 7A.
IC Statement
This device complies with Industry Canada license – ICES-003. Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause undesired operation of the
device.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4. Consult the dealer or an experienced radio / TV technician for help.
This symbol means the product must not be discarded as household waste, and should be delivered to an
appropriate collection facility for recycling.
Declaration of Conformity
Hereby, Anker Innovations Limited declares that the product type A2229 is in compliance with Directive 2014/30/EU.
The full text of the EU declaration of conformity is available at the following internet address:
https://www.anker.com/products
Anker Innovations Limited
To Next Page
Loading...
