1. Stretch the multifunctional extension pole as long as needed, with a maximum length of 1m.
2. Open the extension rod connection port.
3. Tighten the extension rod through the bottom screw.
4. The camping lights can be attached to the extension rod through the magnetic ball.
Uninterruptible Power Supply (UPS)
To use the UPS feature, connect your power station to a wall outlet with the AC charging cable, then press the AC outlet button and connect your devices via the AC output
ports.
SurgePad
™
Using the SurgePad
™
feature, the power station can power high-wattage devices up to 1600W without overload.
SurgePad
™
automatically turns on when the total output exceeds the rated output, allowing the power station to deliver rated power to high-wattage devices.
SurgePad
™
does not function in bypass mode (when the power station is being charged with the AC output on).
SurgePad
™
works better with devices that generate heat, but does not support precision instruments and other devices that have voltage protection or strict voltage requirements. To
see if SurgePad
™
works with your high-wattage devices, try powering them with the power station.
Anker App for Smart Control
You can remotely control your power station using the Anker app.
1. Download the Anker app from the App Store (iOS devices) or Google Play (Android devices), or by scanning the QR code.
2. Connect the device to a network before using the app for the
fi
rst time. After connecting successfully, you can connect your device o
ff
-grid.
3. Firmware update: You will be informed once a new
fi
rmware version is detected when you connect the power station to the app. During the update, ensure the power station is AC charged and connected to
Wi-Fi.
Light
Ambient light
Press the button once to turn on the ambient light, and press again up to 2 times to switch between brightness levels.
SOS Mode
Hold the button for 2 seconds to turn on SOS mode.
FAQ
To Next Page
Loading...
