Command Directory 3-4 Commands
MG369xC GPIB PM PN: 10370-10374 Rev. F 3-55
LEA
Description: Learn list (in list sweep mode).
During the initial list sweep, the MG369xC performs calculations to set the frequency
and power levels. This causes the initial list sweep to take longer than each subsequent
sweep. The command LEA initiates a process that examines every index in the current
list and performs all the calculations necessary to set the frequency and power levels.
This lets the initial list sweep be as fast as each subsequent sweep. The list calculations
are for the current list only. Any changes to the current list or selection of another list
requires the calculations to be performed again. The calculations are stored only in
volatile RAM and are lost when power to the instrument is turned off.
Functional
Category: LIST SWEEP
Related
Commands: LST, ELN(x)
Front Panel Key: Frequency | List | Pre-calc List
LF <value> <unit>, <value> <unit>
Sets list frequencies starting at the list index.
Functional
Category: LIST SWEEP
Value: Frequency range of the MG369xC model
Units: GH, MH, KH, HZ
Description: Permits setting the list frequencies of the selected list starting at the list index specified
by the command ELI(xxxx). Any number of frequencies can follow this command. This
command does not change the value of the list index.
Example: LST; ELN1; ELI1234; LF 2 GH, 5 GH, 1 GH, 8 GH; LP 2 DM, 9 DM, 3 DM,
10 DM
Places the instrument in list sweep mode, selects list number 1, and sets the list index to
1234. List index 1234 is set to 2 GHz at 2 dBm, list index 1235 is set
Related
Commands: LST, ELN(x), ELI(xxxx)
Front Panel Key: Frequency | List | Frequency List. . . | Edit Selected
To Next Page
Loading...
Need help?
General
