

INSTRUCTION FOR AUTOMATIC LEAD ACID BATTERY CHARGER ALCS 2-24 A

USE OF THE CHARGER

Automatic charger for sealed lead acid batteries 2 V up to 24 V with the capacity range from 2.4

Ah to 24 Ah.

FEATURES

For charging sealed lead acid batteries:2V, 6V, 12V or 24V; Automatic adjustment to the correct

voltage of connected battery; For all types of sealed lead acid batteries; Protection against overload

and short circuit by current limitation; Protection against wrong polarity by polyswitch; Charging with

IU-curve; Suitable for ﬂoat charging; Trickle charge approx 20mA

DISPLAY

LED red on: charging of the battery

LED red off: end of charging / trickle charging

LED green: after connecting the battery one of the 4 green LED´s indicates the voltage of the connected

battery. If no battery is connected the LED for 24 V will light.

ATTENTION

Only for charging rechargeable lead acid batteries. Do not charge other types of batteries -

Danger of explosion!

COMMISSIONING

Connect the battery with the battery clips. Pay attention to the correct polarity. The black one with

-, the red one with +. Plug the charger into a convenient mains socket. If no battery is connected the

green LED for 24 V will light. After connecting the battery, the charger switches automatically to the

right voltage and the charging procedure will start. The red LED indicates charging. After charging

the red charging LED switches off and the battery is provided with trickle charging. The battery is now

fully charged and ready for use.

WARNING

When charging lead acid cells, explosive gases can develop. Avoid open ﬁre and sparks.

TIP

Do not carry out any cleaning if the charger is plugged in. Only use a dry cloth to clean the charger.

Do not use the charger if the housing is damaged. Chargers that require repair must be sent to

authorised service agents or dealers.

ANSMANN ALCS 2-24 A - Page 19

Other manuals for ANSMANN ALCS 2-24 A