Next, take out the rechargeable battery pack and clamp
it again, but this time ensure that the contact pins of
the charger and battery pack are touching. The charger
will automatically adjust to the polarity of the pack so
connection can be made either way.
If the battery pack has more than two connections, ensure
that the + and – contacts are chosen.
Once the connecting has been veried by the charger the
green LED will start to ash to indicate that the charging
process has started. After charging is complete the LED stops
ashing and stays on.
If the red LED is ashing the rechargeable pack may be
faulty and need replacing.
For standard round cells please insert the AA Mignon or the
AAA Micro rechargeable cells into the appropriate charging
slots.
Please pay attention to insert with the correct polarity.
The charge will turn o automatically when the cells are full.
If for any reason the cells do not exhibit the right “battery
full” characteristics, the integrated safety timer terminates
the charging procedure after 10 hours.
For an optimum performance we recommend using Li-Ion
rechargeable battery packs and NiMH cells from ANSMANN
Technical details subject to change without prior notice. No
liability accepted for typographical errors or omissions.
Rechargeable batteries are not to be disposed of in domestic
waste. Used batteries should be returned to a battery
recycling collection depot.
Universal fast-charger with Vmax technology for Li-Ion, Li-Po
rechargeable batteries with 3.6 V/3.7 V, 7.2 V - 7.4 and AA
and AAA rechargable batteries.
Charging current: 700 mA
Digicharger Vario
Mains cable 110 - 240 V
12 V car plug
3 years warranty
To Previous Page
Loading...
Need help?
General
