USE
Fit the mains plug (different mains plugs may be included, e.g.
Euro, UK, US or AU, depending on the design and the specific
country variant) onto the two mains contacts and slide it on
until it reaches the stop in the guide (see illustration). Ensure
that the plug latches into place audibly when sliding on. The
charger is now ready for use.
To release/change the mains plug, press the locking tab
carefully (e.g. with a ballpoint pen) downwards a little and
slide the plug back.
Plug the charger into a suitable mains outlet. The charger‘s
readiness for operation is indicated by the brief illumination
of both LEDs. You can insert one or two NiMH or NiCd 9V PP3
rechargeable batteries with a nominal voltage of 8.4V into
the charge slots. Ensure that the rechargeable batteries
are inserted with the correct polarity, matching with the
symbol beside the charge slot. The charge process starts
automatically and is indicated by the red LED for the respective
slot illuminating. The rechargeable batteries do not need to
be inserted at the same time as the charge process for each
rechargeable battery is controlled independently. Warming
of the rechargeable batteries during the charge process is
normal. After successfully charging a rechargeable battery,
the LED illuminates green and the charge process switches
automatically to pulse maintenance charging. This function
guarantees optimum performance and prevents the self-
discharge of the rechargeable battery.
[
KLICK
]
To Next Page
Loading...
Need help?
General
