Ansul AUTOPULSE IQ-396X - AMG Tone;Message Selections (SW2=Off); Table 1: Tone and Message Selections (SW2=Off)

30 AUTOPULSE IQ-396X Programming Doc. 50402:B 07/22/96
Warning sounders connect to any of the four panel Notification Appliance
Circuits or to CMX module circuits (refer to the IQ-396X Installation
Manual). The same releasing hazard can activate multiple Notification
Appliance Circuits.
...rednuosaetavitcaoT....sihtoD
nehw,stratsremityaledehtnehW
ro,setavitcaecivedgnisaelereht
.htob
gnisaeleraoteludomXMCehtpaM
.)9R-0R(enozdrazah
ehtfoenonehwyletaidemmI
.etavitcasecivedgnitaitini
ton(enozetarapesaotXMCehtpaM
llaotdeppamoslasitaht)9R-0R
.drazahehtfosecivedgnitaitini
 If selecting cross-zoning,
this sounder only activates
when two zones go into
alarm.
 Unlike release solenoids,
sounders do not wait for
the delay timer.
 If coded sounds are
required for warning
sounders, they must use
one of the four panel
Notification Appliance
Circuits, not a CMX
circuit.
Activating a Warning Sounder
The following table contains instructions for using control functions:
fI...sihtoD
noitacilppagnisaelerA
syalerlortnocseriuqer
tcatnocyrdroftesseludomXMCesU
syalerlortnocehtmargorP.noitarepo
ehtgniwollofybsnoitcnuftnereffidrof
srednuoSgninraWnisnoitcurtsni
.evoba
lortnocgnidivorP
snoitcnuf
eludomyaleretomerR8-MCAnaesU
ehtfosenozerawtfosehtotdeppam
Warning Sounders
Auxiliary Control Functions
Using Control Functions
The following table contains instructions for annunciating ACS points and
detectors:
...SCAetaicnunnaoT...sihtoD
gnisaelerfostnioP
snoitcnuf
senozerawtfosehtfoynaetaicnunnA
-0Rsenozgnidulcni,evobadebircsed
.9R
srotcetedlaudividnIetarapesaotrotcetedhcaengissA
ehtetaicnunnadnaenozerawtfos
ACS Annunciation
Annunciating ACS Points and Detectors