Ansul CHECKFIRE 110 Owner's Guide

PAGE 2
IN CASE OF FIRE: Manual Actuation
PUSH RED BUTTON FOR
IMMEDIATE ACTIVATION
OPEN
GUARD DOOR
009241
1) Safely bring equipment to complete stop, set brake and
shut off engine.
2) Break visual seal and open guard door.
3) Push the red “PUSH To Activate / Alarm When Lit” button.
4) Release circuit immediately activates the connected fire
suppression system (if included, pressure switch activates
auxiliary operation). See Note below.
5) Safely exit equipment and stand-by with supplemental
firefighting equipment.
6) Optional manual actuation: Pull ring pin and strike red
button on electric or pneumatic manual actuator.
Note: The red “PUSH To Activate / Alarm When Lit” LED and
sounder remain steady-on for 10 sec. during initiation (release)
of fire suppression system. Post release: “PUSH To Activate/
Alarm When Lit” and Release LEDs and sounder continue to
pulse 1 x 10 sec. If safe to re-enter equipment, push “DELAY/
Reset/Silence” button to silence sounder for two hours.
Electric or Pneumatic Manual Actuator Location(s):
Fill-In System Information (as installed)

Ansul CHECKFIRE 110 Specifications

General

Brand	Ansul
Model	CHECKFIRE 110
Category	Control Systems
Language	English