Electric Detection/AUTOPULSE Control System
(Continued)
Perform system annual maintenance by following the
instructions listed in the appropriate AUTOPULSE Control
System Installation, Operation, and Maintenance Manual.
To test the operation of the valve actuator, apply power to
the circuit the actuator is installed on. When power is
applied, a “click” will be heard. This will confirm the actuator
is functioning.
Also, check the actuator on the selector valve. The “click”
should also be heard, confirming the actuator is operating.
When all tests have been completed, make certain all con-
trol panels are returned to the normal condition and the
valve actuator(s) have been correctly reinstalled back on
the cylinder valve.
SECTION X
UL EX-4510 12-1-01 Page 10-4
Maintenance
To Next Page
Loading...