TROUBLE SHOOTING
Poor Signal Strength (analogue)
If the picture suffers from snowy grainy signal try the
following to improve the picture:
1. Tilt and rotate antenna to obtain best picture result
2. Adjust Gain control to obtain best picture result.
3. Position antenna at greater or lesser distance from TV
until optimum signal is received.
4. Check the mains connection and fuse
Poor Signal Strength (analogue)
If the picture suffers from herringbone pattern across
screen:
1. Adjust Gain control to obtain best picture result.
Problems with DTT (Digital Terrestrial Television)
Unlike analogue terrestrial television, it is not possible to
view DTT channel under weak signal strength
conditions. Therefore, typically you will either receive
DTT channels with a clear picture and sound or you
will not receive any channels at all. Sometimes, an
insufficient digital signal can cause occasional blocking,
freezing or complete loss of picture. Try the following to
improve the picture:
1. Tilt and rotate antenna.
2. Adjust Gain control.
3. Position antenna at greater or lesser distance from TV
until optimum signal is received.
4. Check the mains connection and fuse.
Blocking, freezing or complete loss of picture can also
occur when a digital signal is too strong.
1. Adjust Gain control to obtain best picture result.
Note: In difficult reception areas indoor antenna’s may
not perform as well as outdoor antenna’s
CPIN981/2
ANTSIG an Arlec consumer Products Brand
For all Sales Phone (03) 9982 5111 Fax 1300 360 650
AP537_Instructions.indd 2 19/12/11 11:35 AM
To Previous Page
Loading...