10
P/N 1011458 Rev D 01/22
Operations
Initial Startup
1. Connect the cold water line to the water inlet according
2. Plug the power cord into the appropriate outlet. Turn on
water.
3. The steamer performs a system test and displays
information on the display.
4. The steamer then shows the splash screen. Press the
Power Button behind the Display to turn the steamer
on.
Power Button (Rear of Steamer)
Power
Button
5.
internal tank. When complete the steamer displays the
Initial Warm-up Screen appears. This screen shows the
time remaining for the warm up operation.
6. When initial Warm-up completes, the steamer displays
the operation screen.
Symbol Meaning Possible Values
BT Boiler Temperature Degrees
AT Control Board
Temperature
Degrees
TP Top Probe
BP Bottom Probe
SN Snap Switch
CN Contactor
DV Drain Valve
CV Clean Valve
RV Right Cavity Steam Valve
LV Left Cavity Steam
Valve
LV Left Cavity Steam Valve
PID 0-100
This section describes the icons that appear on the display.
Icon Descriptions
Increase Icon. Used to increase a value.
Increments vary across items.
Decrease Icon. Used to decease a value.
Increments vary across items.
Save Icon. Used to save data to the control
board memory.
Cancel Icon. Used to cancel the current
activity.
System Settings Icon. Used to access and
change system settings.
Screen Information
Status Bar
Boiler Temperature
Percentage
(00/100)
Water Probe
State
(Wet/Dry)
Time Left for
Complete Warm-up
To Next Page
Loading...