8
P/N 1011458 Rev D 01/22
Leveling the Steamer
NOTE: Installer MUST verify the weight
restrictions of the table, cart, or
service rack prior to installation
of the steamer. All warranties
will be VOID if work surface is
unabletohandlethespecied
weight load.
1. Using two people to safely lift the
work surface that is capable of with-
standing the necessary weight. 150
pounds for a single steamer or 360
pounds for a double stacked steamer.
2. Check the clearances table on the
previous page for walls and other
equipment to ensure that all codes
and recommendations are followed.
3. Using a level, rotate the adjustable
feet until the steamer is level. The
steamer should be level by depth and
4. If double stacking steamers, follow
the next section of instructions. If not
double stacking, move on to the Water
Drainage instructions on the next
page.
NOTE: If steamer is not level, adjust
the mounting feet until level is
achieved.
R
o
t
a
t
e
t
o
a
d
j
u
s
t
Level Steamer
Double Stacking Steamers
(Optional)
NOTE:TheInniSteamisdesignedfor
a maximum height of two (2)
steamers. Stacking more than
two steamers can cause injury
and/or damage to steamers and
will void all warranties.
1. Ensure bottom steamer is completely
level before continuing.
2. Locate and remove the four (4)screws
on the top cover of the bottom steam-
3. Remove all accessories from the sec-
ond steamer that will be placed on top.
Place accessories aside to keep them
from moving during installation.
4. Using two people, lift the second
steamer and place it carefully on top
of the bottom steamer.
5. Rotate the feet on the steamer to ad-
just height and level the top steamer.
6. Align the screw holes of all four (4)
feet and holes in the top of the base
steamer. Using a screwdriver put the
back in place.
Remove Screws
Double Stacked Steamers
Remove Top Cover Screws
of Bottom Unit
To Next Page
Loading...