AnyTone D868UV Firmware Updating Guide

The radio should not return to the Clock-Set screen display after updating,
you will have to redo the updating if it returns to the Clock-Set screen
display.
8. Reboot the radio when the update is finished.
Please put OFF the GPS and APRS to prevent radio go in TX when connect to
PC ,as it may cause the CPU or memory IC damage.
Important Notice:
Please make sure the codeplug is saved to PC before you do the update
and reset.
Rebooting the MCU
After updating the firmware, you need to reset to the radio
Main Control Unit (MCU).
Power off the radio first. Then power it on while holding the PTT and
the PF1 button below the PTT at the same time. The radio will start up
with a note on the display stating “MCU Reset”.
*** Please Wait – and do not turn the radio off while it restarts ***
After the MCU reboot, you will have to set the time and date.
Use the P1 key to scroll through the date / time fields.
Up and Down arrow keys will allow you to change the information in
these fields. After you have the information entered use the Green key
to confirm the settings.
You will have to reload your saved code plug as the final step

AnyTone D868UV Specifications

General

Brand	AnyTone
Model	D868UV
Category	Two-Way Radio
Language	English