AOC D32W931

45
5. Enter the item “Color Temp” to select Normal to adjust.
6. Use the item R Gain,G Gain or B Gain to adjust white balance: use 80 IRE (Pattern 141) signal, and adjust the
white balance, until the Ca210 show x =285, y =293.
Adjust HDMI Source:
1. Set the pattern generator to timing 347 or HDMI-720P@60Hz timing. And Select the item of Current Source and
select HDMI Source
2. Switch the Ca210 to xyLv-mode (with press “MODE” button)
3. Switch the Ca210 channel to Channel 05 (with up or down “MEMORY CH” button)
4. The LCD-indicator on Ca210 will show x =285, y =293, Lv can adjust to More than 350cd/cm
2
(at full white).
5. Enter the item “Color Temp” to select Normal to adjust.
6. Use the item R Gain,G Gain or B Gain to adjust white balance: use 80 IRE (Pattern 141) signal, and adjust the
white balance, until the Ca210 show x =285, y =293.
Adjust VGA Source:
1. Set the pattern generator to timing 137 or 1024*768@60Hz timing. And Select the item of Current Source and
select VGA Source
2. Switch the Ca210 to xyLv-mode (with press “MODE” button)
3. Switch the Ca210 channel to Channel 05 (with up or down “MEMORY CH” button)
4. The LCD-indicator on Ca210 will show x =285, y =293, Lv can adjust to More than 350cd/cm
2
(at full white).
5. Enter the item “Color Temp” to select Normal to adjust.
6. Use the item R Gain,G Gain or B Gain to adjust white balance: use 80 IRE (Pattern 141) signal, and adjust the
white balance, until the Ca210 show x =285, y =293.
Adjust Component Source:
1. Set the pattern generator to timing 314 or HDTV-720p@60Hz timing. And Select the item of Current Source and
select Component Source
2. Switch the Ca210 to xyLv-mode (with press “MODE” button)
3. Switch the Ca210 channel to Channel 05 (with up or down “MEMORY CH” button)
4. The LCD-indicator on Ca210 will show x =285, y =293, Lv can adjust to More than 350cd/cm
2
(at full white).
5. Enter the item “Color Temp” to select Normal to adjust.
6. Use the item R Gain,G Gain or B Gain to adjust white balance: use 80 IRE (Pattern 141) signal, and adjust the
white balance, until the Ca210 show x =285, y =293.
7. Enter the item “Color Temp” to select Cool to adjust.
8. Use the item R Gain,G Gain or B Gain to adjust white balance: use 80 IRE (Pattern 141) signal, and adjust the
white balance, until the Ca210 show x =272, y =278.
9. Enter the item “Color Temp” to select Warm to adjust.
10. Use the item R Gain,G Gain or B Gain to adjust white balance: use 80 IRE (Pattern 141) signal, and adjust the
white balance, until the Ca210 show x =313, y =329.