19’’ LCD TV AOC L19W631
10
Press the number buttons to enter the new password again, to confirm.
TV Setup
The following menu appears only in the TV mode.
1. Program no.: Shows the current channel number. You can change program no with left/right key of remote
control.
2. Tuning mode: Select the mode of TV signal –Cable
3. TV System: There are four options as NTSC-M, Auto, PAL-M and PAL-N. Recommend set it to auto.
4. Auto search: Select "Auto Search" to search all signaled channel; when the search is complete, it stays at the
first channel with signal and all channels that have been located are stored. If you would like to stop "Auto
Search" during the process, press the Menu button.
5. Fine Tuning: Fine Tune frequency of current program.
6. AFC: AFC can be set to ON or OFF. When it is set to ON, the TV will search the TV signal automatically. When
there is any offset in the signal, it will automatically adjust the channel to the correct position.
7. Skip: can be set to ON or OFF. When it is set to ON, the channel without signal can be skipped by pressing the
up/down button on the remote control or on the front panel.
8. Reset to default: Reset the TV setting to the factory default value.
To Next Page
Loading...
Need help?
General
