文件名称: 售后维修服务手册( 6M181/ 6E181/ 6M182/ 6E182 方案)
Document: After-sales Maintenance Service Manual( 6M181/ 6E181/ 6M182/ 6E182 Scheme)
Page 4 of 4 KTC
Power Mode
Power-up mode (power-on upon powering up, power-off upon powering up, restore
to the previous status upon powering up)
Agi ng Burning ON/OFF.
VD&VI F- NoSt r and1
VD&VI F- NoSt r and2
VI F
VD&VI F- NoSt r and3
VD&VIF parameter adjustment
CH Tabl e1
set f act or y TV channel s
CH Tabl e2 set f act or y TV channel s
Debug mode sel ect i on
UART DEBUG
UART DEBUG Ther e ar e f our i t ems , OFF, HK, AEON and
VDEC. We usual l y choose HK t o enable serial port
debugging.
Al l ki nds of adj ust ment cur ves
MODE Signal source selection
Br i ght ness Cur ve OSD- 0、OSD- 25、OSD- 50、OSD- 75、OSD- 100
Cont r ast Cur ve OSD- 0、OSD- 25、OSD- 50、OSD- 75、OSD- 100
Sat ur at i on Cur ve OSD- 0、OSD- 25、OSD- 50、OSD- 75、OSD- 100
Hue Cur ve OSD- 0、OSD- 25、OSD- 50、OSD- 75、OSD- 100
Shar pness Cur ve OSD- 0、OSD- 25、OSD- 50、OSD- 75、OSD- 100
NONLI NEAR
Vol ume Cur ve OSD- 0、OSD- 25、OSD- 50、OSD- 75、OSD- 100
Fact or y Reset Reset Al l
Sof t war e Updat e（USB） Sof t war e updat e
To Next Page
Loading...
