Note: Within 50 yards, the flag is large. According to the working
principle, laser can't measure the distance difference between
two targets. lt won't vibrate, but can measure distance normally.
Above 50 vards, the flag is small. According to the working
principle, laser can measure the distance difference between
two targets. lt will vibrate, and measure distance normally.
After locking successfully, holding "POWER" button and move to closer targets, you can
active "Continuous scan function".
After activating "Continuous scan function", you can only read target's distance closer
than previous targets.
Notice 1: After activating "Continuous scan function", you can use this function for 10
seconds, that is themaximum measurement time of laser. After 10 seconds, it will stop
reading, and LCD will display the last target's data you measured.
Notice 2: To use this "Continuous scan function" again, just repeat the above operation.
Notice 3: To use "Continuous scan function", do not release "POWER" button after
locking successfully, please pressing and holding "POWER" button to closer targets.
To Next Page
Loading...
