Need help?Do you have a question about the APart-Audio CHAMP-3D and is the answer not in the manual?
General| Channels | 3 |
|---|---|
| Minimum Impedance | 4 Ohms |
| Signal-to-Noise Ratio | >100 dB |
| THD | <0.05% |
| Frequency Response | 20 Hz - 20 kHz |
| Input Impedance | 10 kOhms |
| Damping Factor | >200 |
| Input Sensitivity | 775mV |
| Protection | Overload, short circuit, DC, thermal |
| Power Supply | 230 VAC |
Essential safety guidelines for handling and operating the amplifier, including warnings about sharp surfaces and high sound pressure.
Details on the amplifier's modular design, high thermal efficiency, DSP capabilities, and various connectivity options.
Detailed identification and explanation of all connectors and ports on the rear panel of the amplifier.
Introduction to controlling the amplifier remotely via RS232, including command structure and port settings.
Reference guide to understanding various error messages displayed on the LCD and their potential causes.
Important operational notes on convectional cooling, rack installation, and fuse replacement.
Detailed technical specifications including power output, load impedance, input sensitivity, and S/N ratio.
To Next Page