The subwoofer has no built in crossover or amplier or protection system. We strongly recommend
to use the subwoofer in an active conguration only. Both speakon™ as well as standard speaker
wire connectors are provided.
We recommend the use of high quality speaker cable : 2.5 mm² for distances up to 15 meters.
For longer distances, use 4 mm² or more.
Before pushing your loudspeaker volumes to the edge, take a few minutes to read these
instructions carefully.
1. Keep this manual for future reference.
2. Clean only with dry cloth.
3. Do not operate near heaters or place it on other apparatus which produce a lot of heat.
4. Take care for the speaker leads. Never use damaged leads and install them in such a way
that no one can walk on it.
5. Only use accessories specied by the manufacturer.
6. Make sure the mounting surface can easily support the speaker’s weight.
7. Use only industry-accepted rigging tools and methods.
8. Choose the right speaker for the right job.
9. Use sufcient loudspeakers and avoid death spots.
10. No main power shall be connected to the loudspeakers.
11. This apparatus should only be serviced by qualied personnel. If not, the warranty might be void.
12. Removal of the grill causes risk to loudspeaker damage.
13. Use cables of the right gauge, certainly for long runs.
14. Use cables with clear colour codes and maintain polarity throughout the whole system.
15. Switch ampliers on with the volumes turned completely down to avoid loud clicks and clacks.
16. Avoid loud feedback for this is a main speaker killer!
Music colours our lives but too much sound might damage yours and other’s hearing permanently!
Being exposed to loud sound levels over a long time can cause severe hearing loss.
Don’t forget to consult the local law directions regarding producing sound in public places. In some
countries ear protection is obliged when the continuous sound level over 8 hours time is 80dB (A).
Important safety instructions
Connection
To Next Page
Loading...
