Installation and Quick Start 19
How to Access a Configured Network Management Card
Telnet/SSH
You can access the control console through Telnet or Secure
SHell (SSH), depending on which is enabled. To enable these
access methods, select the Administration tab, the Network
menu on the top menu bar, and the access option under
Console on the left navigation menu. By default, Telnet is
enabled. Enabling SSH automatically disables Telnet.
Telnet for basic access. Telnet provides the basic security of
authentication by user name and password, but not the high-
security benefits of encryption. To use Telnet to access an
Network Management Card’s control console from any
computer on the same subnet:
1. At a command prompt, use the following command line,
and press
ENTER:
telnet address
As address, use the Network Management Card’s IP
address or DNS name (if configured).
2. Enter the user name and password (by default, apc and
apc for an Administrator, or device and apc for a Device
User).
SSH for high-security access. If you use the high security of
SSL for the Web interface, use Secure SHell (SSH) for access
to the control console. SSH encrypts user names, passwords,
and transmitted data.
The interface, user accounts, and user access rights are the
same whether you access the control console through SSH or
Telnet, but to use SSH, you must first configure SSH and have
an SSH client program installed on your computer.
See also
See the Security Handbook: Network Management
Card, available on the APC Network Management
Card Utility CD or from the APC Web site,
www.apc.com, for more information on selecting
and configuring network security.
See also
See the User’s Guide for more information on
configuring and using SSH.
To Next Page
Loading...
Need help?
General
